Rust Arrestor rust remover 0.25L

Rust arrestor can be used on any rusty metal surfaces. The material is suitable for handling fences, old-timers, various types of steel constructions, cleaning tools or machine parts and, of course, your fuel tank!

Properties:

• Removes deep rust pores
• Stops rust expansion
• Prepare rusty surfaces without grit blasting, then apply new paint
• Increases the adhesion for primers and paint systems
• Thin liquid, promotes good penetration into the substrate for maximum effect
• Removes the rust in all seams and crevices
• Safe, no toxic fumes, nonflammable
• You can rinse any spilt Rust Arrestor with water, it's environment-friendly
• Apply at a temperature of 5 degrees Celcius or above
• Keep frost-free
• Do not dilute!
• Keep out of reach of children
• Does not damage surfaces like paint, chrome, aluminium, nickel, copper, etc.

Instructions for general use:

Always place the rust arrestor on dry rust, then let it work for 24 hours. This creates a grey-white powder that can be brushed off or wiped with a damp cloth. Then, it can be further treated with a primer or other paint system. One can also make a bath of Rust arrestor and put metal parts in it. After about 2-3 hours, the rust disappears and after the surface dries, the Rust arrestor can be used again. The liquid continues to work actively! Rust arrestor can also be used to remove rust from fuel tanks. It works perfectly with the EC-Tank sealer. In case of heavy rust, use Rust-arrestor a 2nd time.

Instructions regarding the tank:

The tank must be thoroughly dry before you use Rust Arrestor in it. Shake well so that the product reaches all rust spots well. Then let the tank rest, putting it in a different position every 2 hours so that the product can work in. Repeat this action until you have been around the tank. You can then pour the Rust-arrestor back into the container, possibly filtered (by for example with a coffee filter). Let the tank dry well, as the curing time is at least 24 hours.

If the tank is well dry, rinse it with Thinner. Allow the tank to dry again and then coat it with the EC-Tank sealer.